Bake Particles

Baking particles means freezing the particle stream, including all its modifiers. This can be useful for several reasons:

In extreme cases, very fast particles may behave unexpectedly due to processor inaccuracies — for example, they may pass through deflectors. Baked particle streams avoid this problem since they are calculated much more accurately.
You may want to mix several particle streams but prevent modifiers affecting particles in the other streams. To do this, create one particle stream and its modifiers and bake the stream. Delete the modifiers before you start the next stream and continue in the same manner.
If you are using Team Render to render across a network, jumps may occur in particle streams due to differences between the CPUs.

To bake the particles, select the emitter in the Object Manager, choose the Bake Particles command, set the parameters in the Bake Particles dialog as desired (see below) and click OK. A Baked Particles icon will appear in the Object Manager, to the right of the emitter.

Tip:Have you already read through the Particle System section? This is something that you should definitely do, otherwise you will not understand much from the following.

Enable the Emitter and select the Bake Particles command. In the dialog window that opens, enter the length of time for which the particle stream should be baked using the From and To values. The Project length is entered here by default. Modifying these values will have no effect on the particle stream.

Samples Per Frame

This parameter defines how many animation samples the baking will take per frame. For example, if you set the value to 2, the baking will sample the animation every half frame. In general, higher values lead to more physically correct results, especially with fast-moving particles. Keep in mind that the scene’s file size will increase if you increase the Samples Per Frame value.

Bake Every x Frame

Here you can choose how frequently (in frames) the particles will be baked. For the most accurate results, set the value to 1, which will result in the position being baked for every single frame. With higher values, the positions will have to be interpolated between the baked (saved) values. Keep in mind that the scene’s file size will increase if you lower the Bake Every x Frames value.

You cannot edit the settings that were used to bake the particles. If you need to re-bake the particles — for example, because you have increased the project length — first delete the Baked Particles icon in the Object Manager, then bake the particles again.