--- title: "Advanced Techniques" url: "https://help.maxon.net/zbr/en-us/Content/html/user-guide/3d-modeling/modeling-basics/creating-meshes/zspheres/advanced-techniques/advanced-techniques.html" section_path: "User Guide > 3D Modeling > Modeling Basics > Creating Meshes > ZSpheres > Advanced Techniques" description: "It is possible to distort the shape of a zsphere mesh by using Magnet-Spheres. This technique can be very useful for creating wings and similar shapes or …" --- # Advanced Techniques **Important!** Note: These techniques can only be used with**Classic Skinning**. Turn on Classic Skinning in the [Tool > Adaptive Skin](https://help.maxon.net/zbr/en-us/Content/html/reference-guide/tool/zsphere/adaptive-skin/adaptive-skin.html.md)sub-palette. ### Magnet-Spheres It is possible to distort the shape of a zsphere mesh by using **Magnet-Spheres**. This technique can be very useful for creating wings and similar shapes or adding bulk where it’s needed. ![ZSpheres_magnetP](https://help.maxon.net/zbr/en-us/Content/Resources/Images/ZSpheres_magnetP.jpg) To add a magnet-sphere: 1. In Draw mode, add a regular zsphere at the place where you want the magnet. 2. In Move and Scale mode, adjust position and size of the zsphere. 3. In Draw mode, Alt+click on a Link-Sphere to create the magnet. 4. Press ‘A’ to preview the mesh, adjusting the position or scale as necessary. ![ZSpheres_magnet](https://help.maxon.net/zbr/en-us/Content/Resources/Images/ZSpheres_magnet.jpg) To change a magnet-sphere back to a regular zsphere: 1. In Move mode click on the magnet to select it – this will make its connecting lines appear. 2. In Draw mode, hold down Alt and position the cursor between the lines: the cursor will change to a little square with a minus sign [-]. Click and the grey link-spheres and zsphere will be restored. ### Edgeloop Sockets Edgeloops can be formed by adding smaller zspheres to the model. If these zspheres are moved inwards they will form a ‘socket’, suitable for sculpting eyes and similar shapes. ![ZSpheres_edgeloopP](https://help.maxon.net/zbr/en-us/Content/Resources/Images/ZSpheres_edgeloopP.jpg) To add an edgeloop socket: 1. In Draw mode add a zsphere where you want the socket. 2. In Move mode, move the new zsphere inwards until it appears to pop inside out. 3. The edgeloop socket will have been created. ![ZSpheres_edgeloop](https://help.maxon.net/zbr/en-us/Content/Resources/Images/ZSpheres_edgeloop.jpg) In some circumstances adding two small zspheres one on top of the other can produce a better result; the second zsphere, which is the one pushed inwards, should be slightly smaller than the first. To remove the socket, simply move the zsphere outwards.