Options

Offset [0..100%]

Here you can change the position of the new points along the selected edge. Points that lie one on top of the other will be welded together.

Scale [0.01..+∞%]

If Subdivision is set to 2 or higher, you can use the Scale parameter to adjust the distance between the new points. The scaling takes place in the direction of the first point.

Subdivision [1..100]

Edge Cut applied to the selected edge with Subdivision set to 4. Offset/Scale set to 50/100 (left), 50/30 (center) and 50/80 (right).

Create N-gons

When active, N-Gons will be created. When not active, triangles will be created.