Move Up Sequence

These commands can also be applied to the polygons of a polygon object. As explained in the polygon coordinate system section, the Matrix Extrude tool uses this coordinate system for alignment and this depends on the order of the points of a polygon. You can change this order with Move Down Sequence or Move Up Sequence.

These commands change the order of the points. With Move Down Sequence, the sequence number of each point is incremented and the last point of the original sequence will be the first point in the new sequence. With Move Up Sequence, the sequence number of each point is decremented and the first point of the original sequence will be the last point in the new sequence.

You may also apply the command simultaneously to several segments by Shift+clicking points of these segments. If no points are selected, all points of the spline (and all of its segments) are moved up or down the sequence.