Grow Selection

With this command you can add to a selection. All adjacent points, edges or polygons (depending on which mode you are in) are added to the current selection.

At the left the initial state, at the center after the command was called up with Grow Using Edges Only disabled, at right with Grow Using Edges Only enabled..

This function can also be used on selected UV points and polygons.

The Grow Using Edges Only function works as follows:

• Enabled: All neighboring polygons that share an edge with the original selection will be added to the selection.
• Disabled: All neighboring polygons that share a vertex with the original selection will be added to the selection.